How to use a manual pipe bender

1. Attach base leg (14) onto leg holder (13), secure with lock pin(11) and snap pin (12). 2. Attach frame assembly (8 9) to leg holder (13) and secure with allen screw (5). 3. Attach two rollers (4) between lower frame plate (8) and top frame plate (9), and secure the rollers between frames. Manual Pipe Bender OWNER’S MANUAL Manual Pipe Bender OWNER’S MANUAL 4 of 7 4. Place the bending bracket (4) over the short spacers and secure it using the screw (5), washers (3, 7) and nut (8) according to figure 3 and the parts diagram. 5. Place the long spacer (1) between the back twoholes of the bending bracket and secure. SITE-RITE® Hand Benders Greenlee / A Textron Company Bending — Handle Down (cont’d) 1. Mark the conduit. 2. Insert the conduit into the bender so that the arrow is aligned with the bending mark. 3. Position the bender as shown, with your body as close to the bender as possible. 4. With the handle angled to prevent slipping, apply constant pressure.

conduit and Schedule 40 pipe when used with standard bending shoes. It is intended to bend Schedule 80 pipe through XX pipe when used with ductile iron bending shoes. The bender can accomplish a 90° bend in one shot when using /2" - 2" shoes. Segment bending is required when using /2" - 4" shoes. The bender is to be coupled to any. Inspect the bender before you use it. If something looks questionable don't use it. Try out a new bender with a scrap piece of pipe (if you have one). Remember to take your time when using a new Chicago bender. They take some getting use to and not every one is the same. Most manual tubing benders are versatile enough to bend tubes and pipes up to degrees in a finished form. You can learn how to use a tubing bender in a few simple steps: Step 1: Choose an Appropriate Tubing Bender. All manual tubing benders will have a recommended limitation on the tube or pipe size that it can effectively bend.

When the pipe bending machine is moving, notice that the body is not allowed to enter the rotation sweep of the rotating arm. When the pipe bender works, all personnel are prohibited from entering the space of the rotating arm and the pipe fittings. The hydraulic system of the pipe bender adopts YA-N32 normal hydraulic oil (original number 20). How to Assemble the WFB2 Manual Pipe and Tube Bender Machine from Woodward Fab? Here is your step-by-step guide to assembling the WFB2 manual tube and pipe benders efficiently: Step 1: Positioning; This is the very first step of assembly. When assembling the bender, it is important to ensure that the positioning of the holes and the fixed arm is proper. Artist Kevin Caron shows how to use the hydraulic pipe bender shoes, or dies, to bend metal pipe the right way - including a trick to get the right radius.